Dishlex DX103SK Manuel d'utilisateur Page 12

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 16
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 11
Make sure that the dimensions of the recess agree
with the given dimensions.
1 2
3
4
Adjusting the level of the appliance
Make sure that the appliance is level to close and
seal the door correctly. If the level of the appliance is
correct, the door does not catch on the sides of the
cabinet. If the door does not close correctly, loosen or
tighten the adjustable feet until the appliance is level.
Adhesive steam protection foil
If the worktop is removed, fit the steam protection on-
to the front part of the kitchen cabinet benchtop.
The steam protection foil is not supplied with
freestanding models, but can be purchased
from Electrolux Spare Parts.
Water connection
Water inlet hose
Connect the appliance to a cold water supply.
Connect the inlet hose to a water tap with an external
BSP thread spout of 3/4”.
Inlet water supply
Cold water pressure: 800 kPa max - 50 kPa min.
Water flow rate 10 L / minute min.
If cold water pressure is in excess of 800 kPa, a
pressure reducing valve should be used. Check for
leaks.
Caution! Always use new hoses when you
connect the appliance to the water mains. Old
hoses must not be used. The water inlet hose must
be examined at an interval of twelve months for
deterioration and replaced if necessary.
The water pressure must be in the limits (refer to
'Technical data'). Make sure that the local water au-
thority gives you the average mains pressure in your
area.
Make sure that there are no kinks in the water inlet
hose and that the water inlet hose is not squashed or
entangled.
Fit the hose nut correctly to prevent water leaks.
Caution! Do not connect the appliance to new
pipes or pipes that have been not used for a
long time. Let the water run for some minutes, then
connect the inlet hose.
Water drain hose
The highest point of the drain hose must be no more
than 60 cm from the floor and must have a continu-
ous fall.
The drain hose can be lengthened using additional
lengths and connectors. These must be purchased
from Electrolux Spare Parts. The extension length
must not exceed 2 metres.
12
Vue de la page 11
1 2 ... 7 8 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire